日韩欧美国产综合_国产成人精品网址_欧美大波大乳巨大乳_激情综合五月网_99视频免费观看_欧美日韩国产综合久久_久久在线视频_国产小黄视频_丁香激情五月少妇_国产在线98福利播放视频

PDF全文閱讀

李永^{1 , 2} ,郝文輝² ,趙彥彥³ ,郭朝輝¹,任治立⁴

(1.河北省建筑工程質量檢測中心有限公司，河北 石家莊 050227;

2. 河北科技大學 建筑工程學院 ，河北 石家莊 050018;

3 . 河北建研工程技術有限公司 ，河北 石家莊 050227;

4. 重慶大學 土木工程學院 ，重慶 400045)

摘   要：為了驗證采用模擬計算的方法研究金屬連接件對保溫與結構一體化墻體熱工性能影響的準確性與可靠性，首先依據(GB/T 13475—2008)《 絕熱穩態傳熱性質的測定標定和防護熱箱法》規定的防護熱箱法，制作實驗墻體，并在實驗臺上分別對錨入金屬連接件數量為 3 、6 和 9 個的保溫與結構一體化墻體進行了實驗研究 ，獲取了墻體的實測傳熱系數 。隨后利用Airpak 計算流體力學軟件建立與實驗研究相同的三組模型 ，并設置了相同的熱室與冷室溫度工況 ，分別計算其傳熱系數 。最后對實測結果與模擬結果進行了對比 。結果表明：錨入金屬連接件數量為 3 、6 和 9 個時的保溫與結構一體化墻體平均相對誤差分別為 4. 92% 、4. 69%和 3 . 96% ,  模擬計算誤差均在 5%范圍內，滿足工程計算要求。

關鍵詞 ：防護熱箱法 ；金屬連接件 ；傳熱系數 ；相對誤差

中圖分類號 ：TU55+ 1           

文獻標志碼 ：A           

 文章編號 ：1005- 8249  (2024)   01- 0163- 05

 DOI : 10. 19860/j . cnki . issn1005- 8249. 2024. 01 . 028

LI Yong1 , 2  ,   HAO Wenhui2 ,  ZHAO Yanyan3 ,   GUO Zhaohui 1  ,  REN Zhili4

( 1 . Hebei Province Center for Building Quality Inspection Co. ，Ltd. ，Shijiazhuang 050227 ,   China;

2. Hebei University of Science and Technology College of Civil Engineering ,   Shijiazhuang 050018 ,   China;

3 . Hebei Building Research Engineering Technology Co. ，Ltd. ，Shijiazhuang 050227 ,   China;

4. Chongqing University School of Civil Engineering ,   Chongqing 400045 ,   China)

Abstract：In order to verify the accuracy and reliability of using the method of simulation calculation to study the influence of metal connectors on the thermal performance of thermal insulation and structural integration wall, the experimental wall is first made according to the protective hot box method stipulated in "Determination and Calibration of Thermal Insulation Steady State Heat Transfer Properties and Protective hot box Method" (GB/T13475-2008). Experimental study was carried out on three, six and nine insulation and structural integration walls with anchored metal connectors on the experimental platform, and the measured heat transfer coefficients of the walls are obtained.Then Airpak computational fluid dynamics software is used to establish the same three groups of models as the experimental study, and set the same hot chamber and cold chamber temperature conditions, respectively, to calculate their heat transfer coefficients.Finally, the measured results are compared with the simulated ones.The results show that the average relative errors of insulation and structural integration wall are 4.92%, 4.69% and 3.96% respectively when the number of anchored metal connectors is 3, 6 and 9, and the simulation errors are all within 5%, which meet the requirements of engineering calculation.

Keywords:protective hot box method;metal metal connector;heat transfer coefficient;the relative error

作者簡介：李永(1981—),男，碩士，教授級高級工程師，碩導，主要研究方向：建筑節能與可再生能源建筑應用。

收稿日期：2013-05-19